NOVUS Stabil with staple remover

Useful stapler for any desk
Staple type: 24/6 and 26/6
Stapler with a stapling capacity of 30 sheets
Full-metal device
Top loading system with single staple guide
Movable anvil for temporary and permanent stapling as well as for nailing

显示更多

Maximum number of sheets of 80 g/m² paper. The maximum capacity in this case is 30 sheets.

The stapler's key components are made of solid metal.

This device can process staples of type 24/6 SUPER. A maximum of 100 staples can be inserted.

This device can process staples of type 26/6 SUPER. A maximum of 150 staples can be inserted.

With the top-loading mechanism, the staples are inserted into the stapler after raising the top part.

Maximum stapling depth is 65 mm.

This machine bears the GS approval of product safety.

Color	black blue grey red
Material	The stapler's key components are made of solid metal.
Sheet capacity (80g/sqm)*	30
Loading capacity	100 x 24/6 150 x 26/6
Throat depth	65 mm
Loading system	Top loading system
Compliance	This machine bears the GS approval of product safety.
Model	Office stapler
Staple type	24/6 26/6
Sustainability	Environmentally friendly production

* Maximum number of sheets (80 g/sqm) which can be cut in a single pass

常见问题解答

Why can I only staple once even though the stapler is filled with staples?

You are not using original Novus stacks. The stacks from other manufacturers are incorrectly bent and therefore jam on the stacking carrier and cannot be pushed forward. Original Novus stacks are absolutely true to size and can be easily pushed...

Why does the perforator (B225, B240, B260, B425) stay down after actuation and does not release the paper?

The machine was held at an angle when punching and the lock for the rest position is engaged. To unlock, hold the perforator straight and press again. We recommend punching on the table as shown in the picture, then the perforator cannot lock.

Why do the staple ends not go far enough through the paper when stapling?

For the paper thickness, the staple is chosen too short. The following basic rule applies: 10 sheets of standard paper (80g/sqm) are approx. 1 mm thick. The paper stack height plus 3 mm gives the appropriate staple leg length.

Why do the staple ends come out at the top when stapling?

For the paper thickness, the staple is chosen too long. The following basic rule applies: 10 sheets of standard paper (80g/sqm) are approx. 1 mm thick. The paper stack height plus 3 mm gives the appropriate staple leg length.